So far I have tried PC set to never sleep. It happened 3 times in a row today( not in the same spot) on 30 minute carve. That stopped working w/in a week too We are now on the 3rd watch (because my 9 year old loves it and its 'from Santa'). I had to replace it and bought a 2nd one. It doesn’t happen all the time but part way through the carve ( about 45) the xcarve just stops and Easel says it is finished. We bought replacement batteries but it was the watch itself.
I’ll probably order a powered USB hub from Amazon today as it will eliminate the cable issue completely. I have an Xcarve ( 2018) (1000mm, GRBL 1.1f), I am using Fusion 360 to create the gcode and using Easel to send it.
#SUITCASE FUSION 7 KEEPS STOP WORKING DRIVERS#
My drivers were all up to date and the power management settings were correct so no help there for me.
#SUITCASE FUSION 7 KEEPS STOP WORKING SERIAL#
Your controller must be connected in order to see this.Īlso in Device Manger if you change the View to ‘Devices by Container’ you can see the X-controller listed with the USB Serial Converter and the USB serial port. The collection is in testing (as is LWOTC). To do this, go to the Device Manager under Ports - USB Serial Port. ENG Collection of mods compatible with the new beta version (2 beta) modification LWOTC. One setting that I have changed, after the successful carve so I can’t prove it was the problem, is the COM port number ( from 6 to 2 ) and the speed (from 9600 to 115200). So I’ll just have to wait till it fails again. But if you’re like most people, caring for your teeth is one of those automatic grooming practices that become so much a part of your daily routine that you don’t give it much thought. That’s why your oral hygiene routine can make or break the message your smile sends. Don’t you just love intermittent problems. A smile is an almost universal language, and the biggest part of a beautiful smile is a healthy set of teeth.
I temporarily moved my pc close to the Xcarve then using a short USB cable I ran the same cut ( which had previously failed 4 times) and it worked ! But of course being a pessimist, I reconnected the long active cable and ran it again exactly the same except for no bit and that also worked.
Wow, thanks to Dominik and everyone for all the great suggestions.
0 kommentar(er)
